Sign in | English | Terms of Use
DictionaryForumContacts

   Chinese ⇄
Terms for subject Automobiles containing 啮 合 | all forms | in specified order only
ChineseEnglish
不啮合out of mesh
人字齿啮合herringbone gearing
任意脱离啮合walking-out of mesh
使齿轮啮合throw into gear
使…啮合throw in
变速器使齿轮啮合engage the gearspeed
螺旋齿轮侧面啮合flank contact
齿轮八字啮合octoid
内齿啮合的internally toothed
内啮合的internal-geared
内啮合齿圈internal-geared wheel
内啮合齿圈internally toothed ring
内啮合齿圈internal-geared ring
内啮合齿圈的internal-geared
内外齿啮合换档齿套离合器internal-external gear clutch
内齿啮合换档齿套internal gear clutch
可用啮合极限半径usable-contact limit radius
同步啮合的synchromesh
手动变速器同步器啮合摩擦锥轮engaging friction cone
周期性啮合的齿轮装置hunting gearset
啮咬合meshing
动，名啮咬，接合mesh
动啮接合engage
啮接合位置engaged position
啮接合操纵杆engine lever
啮接合的engaging
啮接合的engaged
得到啮合gain contact
啮合gears
啮合key
啮合接触尤指齿轮齿abut
啮合不良poor engagement
啮合区域zone of action
啮合器开关engage switch
齿轮啮合噪声meshing noise
啮合套换档collar shift
啮合干涉tip interference
啮合平面plane of action
啮合延续时间overlapping
啮合弧arc of contact
啮合弧arc of action
起动机啮合弹簧meshing spring
啮合曲面surface of action
齿轮/链条啮合比系数meshing ratio
齿轮/链条啮合接触比engagement factor
啮合测量仪meshing measuring instrument
啮合深度working depth
啮合点point of engagement
啮合状情况meshing condition
啮合痕迹toeing pattern
啮合的in mesh
啮合的geared
齿轮齿的啮合端end of engagement
啮合精度accuracy mesh
啮合系数mesh coefficient
齿轮啮合线line of contact
啮合线path of contact
齿轮啮合线line of
啮合线长度length of path of contact
啮合角working pressure angle
齿轮啮合长度length of contact
齿轮啮合啮合间隙gash
啮合面active flank
起动机啮合驱动装置meshing drive
变速器啮合的齿轮engaged gear
齿轮啮合齿面entering side
外啮合凸台转子泵abutment pump
外啮合圆柱齿轮式轮边减速器spur-geared wheel reductor
外啮合齿轮式机油泵external gear-type oil pump
外推啮合outboard meshing
外部齿啮合external gearing
齿形带外部齿啮合的externally cogged
外部齿啮合的externally toothed
外部齿啮合的external-geared
外齿啮合的齿形带externally toothed belt
外齿啮合的齿形带externally cogged belt
多齿啮合multi-mesh gear
2对1齿轮啮合指输入轴每转两转，输出轴转一转的齿轮传动two-to-one gear
小齿轮啮合驱动meshing drive
起动机小齿轮啮合驱动装置pinion-engaging drive
齿轮常啮合constant mesh
常啮合中间轴constant-mesh countershaft
常啮合式constant-mesh type
惯性啮合式起动机inertia drive starter
惯性啮合式起动机inertia-drive starterstarting motor
惯性啮合式起动机Bendix-type starter motor (Bendix starter)
惯性啮合式起动机inertia-type starter
惯性啮合式起动机Bendix starter
惯性啮合式驱动齿轮Bendix-gearpinion
惯性式传动啮合装置Bendix drive
手操纵啮接合engagement by hand
换档啮合齿套shifter collar
换档啮合套gearshift sleeve
斜齿轮啮合helical toothing
齿轮无噪声啮合silent mesh
齿轮无噪声啮合silent meshing
齿无噪声啮合noiseless mesh (ing)
无声啮接合silent engagement
齿轮啮合无声啮合quiet meshing
齿轮啮合无声啮合quiet mesh
齿轮有噪声啮合noisy mesh (in g)
有效啮合半径active-contact radius
机械啮合式起动机mechanically-engaged drive starter
比例载荷同步啮合proportional load synchromesh
渐开线齿轮啮合involute gearing
滑动啮合换档式变速器sliding-mesh transmission
变速器同步器滑动啮合齿套sliding coupling
滑移啮合slip engagement
点啮合制齿轮传动point contact gear drive
手动变速器牙嵌式常啮合中间轴dog-type constant-mesh countershaft
电枢滑动啮合式起动机axial engagement starter
直接啮合direct coupling
直齿齿圈啮合spur toothing
瞬时啮合点instantaneous engagement point
突然急速啮合fierce engagement
起动机小齿轮纵向啮合inboard meshing
组合式内啮合行星齿轮机构compound internal planetary arrangement
组合式外啮合行星齿轮机构compound external planetary arrangement
脚操纵啮接合engagement by foot
齿轮脱开啮合de-mesh
脱离啮合out-of-mesh
脱离啮合throw-out of gear
齿轮/凸轮脱离啮合walking-out of mesh
齿轮脱离啮合disengage
脱离啮合的out-of-gear
自动啮接合automatic engagement
节销式啮合link-pin mesh
节齿式啮合tooth mesh
花键多槽齿啮合splining
螺旋齿惯性啮合式起动机screw starter
螺纹啮接合thread engagement
轮齿的啮合engagement of teeth
进入啮合falling-in
动退出脱离啮合jump of mesh
邦迪克斯惯性啮合机构如起动机小齿轮和飞轮齿圈利用惯性啮合inertia drive
轮齿部分啮合partial engagement
重新啮合联锁reengagement
钝滚梢，滚柱齿啮合pin toothing
锁定同步啮合器proportional load synchromesh
非周期性啮合的齿轮装置non-hunting gear set
预啮合传动电磁啮合式起动机pre-engaged drive starter (motor)
预啮合式邦迪克斯起动机pre-engaged Bendix starter
齿轮齿的啮合重叠度tooth overlap
齿轮啮合连接toothing
齿轮啮合gear meshing
齿轮啮合gear in
手动变速器齿轮啮合噪声grating of gears
手动变速器齿轮啮合噪声grating noise
齿轮啮合报警器warning buzzer for engaged gear
齿轮啮合点point of mesh
齿轮啮合防脱结构将齿毂套同花键齿的啮合部加工成锥状，使之不易脱开preventive device for non-engaged gear
转向器齿轮啮合预紧度gear mesh preload
齿轮的啮合engagement of gears
齿轮齿部分啮合partial tooth engagement

Get short URL