Sign in | English | Terms of Use
DictionaryForumContacts

   Chinese ⇄
Terms for subject Technology containing 允许 | all forms | in specified order only
ChineseEnglish
下沉允许量settlement allowance
不允许inadmissibility
不允许数位unallowable digit
不允许输入输出中断disallowed input/output interrupt
不能允许的inadmissible
中断允许与禁止interrupt enable and disable (指令)
价值变量的允许变化范围allowable variation range of value variable
保养允许公差service tolerance
允许permit (证)
允许不圆度permissible out of roundness
允许中断enabled interruption
允许中断标志interrupt enable flag
允许中断触发器interrupt enable flip-flop
允许产量allowance production
允许保护guard enable
允许值allowable value
允许值accepted value
允许偏差allowance variation
允许偏心allowable offset
允许偶然误差admissible random error
允许免税限度exempt allowables
允许公差allowable deviation
允许公差allowance tolerance
允许公差tolerance
允许公差acceptance tolerance
允许冲击荷载impact allowance load
允许力矩moment allowance
允许区截permissive block
允许压力maximum permissible pressure
允许压力authorized pressure
允许压差permissible pressure difference
允许压差allowable pressure difference
允许压降allowable pressure drop
允许变形量fairness limit
允许吃水allowance draft
允许吃水admissible draught
允许吸上真空高度permitted vacuum height of intake
允许吸上真空高度allowable suet lift
允许噪声级acceptable noise level
允许坍塌的护脚棱体falling apron
允许外部中断external interrupt enable
允许定时中断timer interrupt enable
允许尺寸偏差allowable dimension variation
允许工作压力safe working pressure
允许工作负荷safe working loading
允许工作负荷safe working load
允许平均声强度specific normal acoustical admittance
允许平均声强度specific normal acoustic admittance
允许应力allowance stress
允许应答acknowledge enable
允许开孔直径allowable opening diameter
允许开采模数法permissible mining modulus method
允许开采量allowance production
允许开采量allowable mining yield
允许强度proof strength
允许强度allowance strength
允许当量裂纹尺寸allowed equivalent crack length
允许形式type permitted
允许形式permissible type
桩的允许承载力point-bearing capacity
允许抽水时间allowed pumping tie
允许抽水量allowed pumping amount
允许抽水降深allowed pumping drawdown depth
允许拆除wrecking permit
允许振动permissible vibration
允许振动allowance vibration
允许掉头的交叉口turn crossing
允许接近速度permissible approach speed
允许摇摆程度lurching allowance
允许放射性allowable radioactivity
允许故障率permissible error
允许故障率allowable error
允许故障率admissible error
允许故障率acceptable failure rate
允许故障率acceptable failure error
允许数值permissible level
允许数字admissible mark
允许文件输入file enable input
允许暴露时间permitted exposure time
允许最低发热量admissible minimum of caloricity
允许最低回收率cut-off rate
允许最高转速maximum allowable speed
允许有一定增减的条款plus or minus clause
允许条件enabled condition
允许模式permissive mode
允许水力梯度permissible hydraulic gradient
允许污染极限permissible contaminant limit
允许污染物浓度admissible pollutant concentration
允许污水排放浓度allowable concentration of waste water disposal
允许污水排放量allowable discharge of waste water
允许波况acceptable wave condition
允许流速permissible velocity of flow
允许液面level allowance
允许淹没深度allowable flooding depth
允许渗透的排水管线drain pipe line allowing infiltration
允许渗透量permitted leak
允许温差allowable temperature difference
允许温度allowance temperature
允许烟雾浓度allowance smoke concentration
允许热损失permitted heat loss
允许状态enabled state
允许状态信号state enable signal
允许电压升降permissible voltage fluctuation
允许电平enable level
允许电流permissible current
允许的最高水位allowable maximum water level
允许的辐射级tolerance level
允许相对偶然误差admissible relative random error
允许着陆permission to land
允许硫含量permissible sulfur
允许磨损permissible wear
允许磨耗tear-and-wear allowance
允许磨蚀度corrosion allowance
允许离差permissible deviation
允许程序存储programme store enable
允许程序存储program store enable
允许算术俘获arithmetical trap enable
允许算术俘获arithmetic trap enable
允许算术自陷arithmetical trap enable
允许算术自陷arithmetic trap enable
允许绝对偶然误差admissible absolute random error
允许腐蚀厚度corrosion allowance
允许荷载proof load
允许行动联络装置permissive action link device
允许解除permissive release
允许试样量permissible sample size
允许试验压力allowable test pressure
允许试验量permissible sample size
允许误差errors excepted
允许误差leeway
允许误差permissible error
允许负差negative allowance
允许质量指标acceptance quality level
允许质量指标acceptable quality level
允许起飞permission to take off
允许超宽allowance over-width
允许超挖线B-line
允许超深over-depth allowance
允许超深allowable over-depth
允许超车free passing of cars
允许趋近极限acceptable close limit
允许载荷量carrying capacity
允许过载的持续额定功率值continuous rating permitting overload
允许进位信号carry clear signal
允许通车间隔allowance gap
允许速度permissible velocity
允许配带最大功率allowable mating maximum power
允许量分配模型tolerance distribution model
允许闩锁latch enable
允许间隙safety clearance
允许间隙permissible clearance
允许限度consent limit
允许静水压力值allowable value of statical water pressure
允许静水压力值allowable value of static water pressure
允许预推信号allow to approach the humping signal
允许频率tolerance frequency
允许飞机通过clear an aircraft to pass
农药允许残留量pesticide residue tolerance
区段允许速度permissive speed in district
可允许的tolerable
可允许的最大浓度maximum allowable concentration
可允许角acceptance angle
叶片的允许速度bladed allowable speed
各阶段最多允许时间标准elapsed time standard
含水层允许疏干年限the number of years set for allowable aquifer dewatering
含水层允许疏干深度depth of allowable aquifer dewatering
含水层年允许疏干率rate of allowable aquifer dewatering
噪声评价允许值曲线NCA noise criterion allowable curve
圆周焊缝的允许偏移allowable offset in circumferential joints
土壤的允许承载压力allowable soil pressure
土壤的允许耐力allowable soil bearing strength
地下水允许开采模数allowable mining modulus of groundwater
基底允许坡度allowable gradient of bed base
天然地基允许荷载subsoil permissible load
安全允许公差safe tolerance
安全允许应力safe allowable stress
安全允许荷载safe allowable load
室内温湿度允许波动范围allowed indoor fluctuation of temperature and relative humidity
岩石允许流速allowable velocity of flow of rock
异常允许exception enable
当被允许时when permitted
截齐允许量allowance for trim
批内允许故障率lot-tolerance failure rate
批内插允许次品率lot-tolerance percent defective
批内插允许破损率lot-tolerance failure rate
批量允许不良率lot-tolerance percent defective
接缝允许间隙joint allowance
收缩允许量allowance for shrinkage
放射性允许浓度permissible concentration of radioactivity
日平均最高允许浓度daily average maximum permissible concentration
暂行最大允许含量temporary tolerance
暂行食品最大允许含量temporary food tolerance
最低允许minimum permissible temperature
最大允许人体负荷maximum permissible body burden
最大允许使用温度maximum permissible service temperature
最大允许值maximum permissible value
最大允许偏差maximum allowable offset
最大允许加速度maximum permissible acceleration
最大允许含尘量maximum permissible dustiness
最大允许抓取重量maximum allowable weight capacity
最大允许曝光量maximum permissible exposure
最大允许机体负荷maximum permissible body burden
最大允许水位下降值maximum allowable water table decrease
最大允许水平maximum allowable level
最大允许流速maximum permissible velocity
最大允许浓度maximum admissible concentration
最大允许浓度exempt concentration
最大允许浓度maximum acceptable concentration
最大允许浓度maximum permissible concentration
最大允许牵引荷载maximum permissible drawbar load
最大允许表速maximum permissible indicated speed
最大允许试样量maximum allowable sample size
最大允许误差margin of error
最大允许转速maximum permissible speed
最大允许轴荷重maximum admissible axle load
最大允许载重maximum allowable load
最大允许辐照maximum permissible exposure (量)
最大允许进人内部量maximum permissible intake
最大允许速度maximum permissible speed
最大允许量maximum magnitude
最大允许高度maximum allowable level
最大可能允许量maximum possible magnitude
最小允许含量minimum permissible content
最小允许流量minimum acceptable flow
最小允许电流minimum acceptable current
最小允许量minimum acceptable discharge
最高允许值threshold limit value
最高允许利率usury ceiling
最高允许压力maximum working pressure
最高允许速度maximum permissive speed
最高允许速度maximum permitted speed
最高允许速度maximum permissible speed
最高允许速度maximum authorized speed
最高允许工程造价fixed limit of construction cost
最高产量与允许产量之差shut in production
有害杂质平均允许含量admissible average content of harmful impurity
有害组分平均允许含量average allowable amount of harmful components
极限允许污染量limiting pollutional load
极限允许浓度limiting concentration
残留允许量practical residue limit
每日允许摄入量acceptable daily intake
水平允许偏差horizontal tolerance
法律允许的allowed by law
注浆孔允许偏斜率allowable deviation of grouting hole
焊接允许的最低温度lowest permissible temperature for welding
环境允许生物降解environmentally acceptable biodegradation
目标变量的允许变化范围allowable variation range of objective variable
短期允许承载力short-term allowable bearing capacity
确认允许acknowledge enable
管道允许流速permissible pipe velocity
纵向焊缝的允许偏移allowable offset in longitudinal joints
线路允许速度railway permitted velocity
线路允许速度permissive speed on track
统计允许极限statistical tolerance limit
统计允许极限statistic tolerance limit
维修允许公差maintenance tolerance
缺点允许率lot-tolerance percent defective
计划允许planning permission
设计允许渗入量infiltration design allowance
轴承允许荷载bearing capacity
较大允许信号more favorable signal
通过车站允许速度permissive speed of train passing through station
锅炉水质允许限度quality tolerance of boiler water
长期允许承载力long-term allowable bearing capacity
验收允许公差acceptance permissible variation
验收允许量acceptance tolerance
高峰允许负荷peak load allowance
高峰允许负荷peaking load allowance

Get short URL